A nuclide is defined as?

Answer:

░░ ░░░░▄░░░░░░░░░ ▄ ░░░░░░░░▌▒█░░░░░░░░░░░▄▀▒▌ ░░░░░░░░▌▒▒█░░░░░░░░▄▀▒▒▒▐ ░░░░░░░▐▄▀▒▒▀▀▀▀▄▄▄▀▒▒▒▒▒▐ ░░░░░▄▄▀▒░▒▒▒▒▒▒▒▒▒█▒▒▄█▒▐ ░░░▄▀▒▒▒░░░▒▒▒░░░▒▒▒▀██▀▒▌ ░░▐▒▒▒▄▄▒▒▒▒░░░▒▒▒▒▒▒▒▀▄▒▒▌ ░░▌░░▌█▀▒▒▒▒▒▄▀█▄▒▒▒▒▒▒▒█▒▐ ░▐░░░▒▒▒▒▒▒▒▒▌██▀▒▒░░░▒▒▒▀▄▌ ░▌░▒▄██▄▒▒▒▒▒▒▒▒▒░░░░░░▒▒▒▒▌ ▌▒▀▐▄█▄█▌▄░▀▒▒░░░░░░░░░░▒▒▒▐ ▐▒▒▐▀▐▀▒░▄▄▒▄▒▒▒▒▒▒░▒░▒░▒▒▒▒▌ ▐▒▒▒▀▀▄▄▒▒▒▄▒▒▒▒▒▒▒▒░▒░▒░▒▒▐ ░▌▒▒▒▒▒▒▀▀▀▒▒▒▒▒▒░▒░▒░▒░▒▒▒▌ ░▐▒▒▒▒▒▒▒▒▒▒▒▒

Explanation:

Answer:

Argon

Explanation:

Argon because chlorine is atomic number 17 and potassium is atomic number 19

Argon is between them thank you

Answer:

H₃P phosphidic acid

Explanation:

The Trihydrogen monophosphide, as stated in the exercise, can act as an acid. This is pretty similar to the case of hydrogen chloride, which is a gas but it can also be an acid, in this case, chloridic acid.

In the case of trihydrogen phosphide, we can write it molecular formula which is:

H₃P

Now, this is a binary compound because its composed of only two elements, in this case, hydrogen and phosphide. To name binary acid, we need to name the non metal with the sufije idic, and then, the word acid.

Following this simple rule, the trihydrogen phosphide would be, as acid:

H₃P: phosphidic acid

Hope this helps

Answer:

2KClO3 = 2KCl + 3O2

I hope it's helps you

84.2565

Because

1 silica is equal to 28.0855,

times 3 is 84.2565

Answer:

Hi, there the answer is

A)extrusion

Explanation:

The feature that causes a gap in the geologic record is called extrusion.

Sometimes magma can force itself through a crack or fault in the rock at the Earth's surface. It pours out over the Earth's surface in a volcanic eruption. This process is called extrusion. The rocks that form from extruded magma are called extrusive igneous rocks.

Direct Extrusion, Indirect Extrusion, Hydrostatic Extrusion and Lateral or Vertical Extrusion are some types of extrusion.

Lava that hardens on the surface is called an extrusion. The rock layers below an extrusion are always older than the extrusion. Beneath the surface, magma may push into bodies of rock. There, the magma cools and hardens into a mass of igneous rock called an intrusion.

Therefore, The feature that causes a gap in the geologic record is called extrusion.

Learn more about extrusion, here:

https://brainly.com/question/30554658

#SPJ5

The Answer Is Sample A

Density -

[tex]density = \frac{mass}{volume} [/tex]

Input The Formula For Both Equations To Find Density.

Sample A -

[tex]d = \frac{40}{10} [/tex]

[tex]d = 4[/tex]

Sample B -

[tex]d = \frac{45}{15} [/tex]

[tex]d = 3[/tex]

The given reaction is a combination / synthesis reaction, since two reactants combine to form a single product

Answer: D

Explanation:

The car will move to the left because Sam is implying a grater force (3 N < 6 N) but it is traveling at a constant speed because there is still a force being acted upon it. <3

The result of applying forces to a toy car is required.

Option D is correct.

Force applied by Bobby is 3 N to the right

Force applied by Sam is 6 N to the left

Right is taken as positive and left is taken as negative.

m = Mass of toy

a = Acceleration

Net force applied to the toy

[tex]F=3-6\\\Rightarrow F=-3\ \text{N}\\\Rightarrow ma=-3\\\Rightarrow a=\dfrac{-3}{m}[/tex]

So, the toy will move left with a constant acceleration.

Constant acceleration means its speed will be increasing.

So, option D is correct.

Learn more:

https://brainly.com/question/18373733?referrer=searchResults

Answer:

203.63 K

Explanation:

Using Charles law equation,

V1/T1 = V2/T2

Where;

V1 = initial volume (mL)

V2 = final volume (mL)

T1 = initial temperature (K)

T2 = final temperature (K)

According to the information in this question,

V1 = 675.6 mL

V2 = 410.9 mL

T1 = 61.8°C = 61.8 + 273 = 334.8K

T2 = ?

Using V1/T1 = V2/T2

675.6/334.8 = 410.9/T2

Cross multiply

675.6 × T2 = 334.8 × 410.9

675.6T2 = 137569.32

T2 = 137569.32 ÷ 675.6

T2 = 203.63 K

Answer: Gene Characteristic. (They are usually made up of more than one gene).

Answer: B. Hydrogen Bonding

Explanation: I got it right on castle learning lol

There are different kinds of forces. The term that identifies a type of intermolecular force is hydrogen bonding.

The three known to be types of intermolecular interactions. They  are

Hydrogen bonding is known to be an intermolecular force that takes place between two molecules. That molecule is known to have a hydrogen atom be bonded to a nitrogen, oxygen, or fluorine atom.

Learn more about Bond from

https://brainly.com/question/1420470

Answer:

A

Explanation:

HOPE THIS HELPS

Answer:

the concentration of hydrogen iodide will be higher than it was in the original equilibrium conditions.

tje new preasure is 10.7l

Answer:

The energy required is 8660.96 J.

Explanation:

Calorimetry is the measurement and calculation of the amounts of heat exchanged by a body or a system.

Sensible heat is the amount of heat that a body absorbs or releases without any changes in its physical state (phase change). This heat is given by the expression:

Q = c * m * ΔT

where Q is the heat exchanged by a body of mass m, made up of a specific heat substance c and where ΔT is the temperature variation.

In this case, you know:

Replacing:

Q= 4.18 [tex]\frac{J}{g*C}[/tex] *74 g* 28 C

Solving:

Q= 8660.96 J

The energy required is 8660.96 J.

Answer: There is 0.8 liters (L) of water required to be added to prepare 4800mL of 0.5M NaCl from a 3M NaCl stock solution.

Explanation:

Given: [tex]M_{1}[/tex] = 0.5 M        

[tex]V_{1}[/tex] = 4800 mL

Convert mL into L as follows.

[tex]1 mL = 0.001 L\\4800 mL = 4800 mL \times \frac{0.001 L}{1 mL}\\= 4.8 L[/tex]

[tex]M_{2}[/tex] = 3 M

Formula used to calculate the volume of water required as follows.

[tex]M_{1}V_{1} = M_{2}V_{2}[/tex]

Substitute the values into above formula.

[tex]M_{1}V_{1} = M_{2}V_{2}\\0.5 M \times 4.8 L = 3 M \times V_{2}\\V_{2} = \frac{0.5 M \times 4.8 L}{3 M}\\= 0.8 L[/tex]

Thus, we can conclude that 0.8 liters (L) of water need to be added to prepare 4800mL of 0.5M NaCl from a 3M NaCl stock solution.

Answer:

flow of electrons

Explanation:

took the quiz

Answer:

50g

Explanation:

moalr mass of CaCO3= 40g/mol+ 12g/mol+(16g/mol*3)

                                   =52g/mol+48g/mol

                                   =100g/mol

1 mol= 100g

0.5mol=x

by cross multiplication,

0.5*100gmol=x mol

x=50g

Answer:

A precipitation reaction is one in which substances in solution are mixed and an insoluble product is made. The insoluble product is called a precipitate and can be seen as a solid forming in the reaction mixture.

Answer:

No they form nitrogen oxide which can be poisonous to some species but depending on the amount of nitrogen it can be harmful to everything living. Such as if you put it with a plant that had low nitrogen levels then there would be no carbon dioxide to filter.

Explanation:

Answer:

So the total mass is 50 plus 150 grams the heat capacity 4.18 joules per gram per degree C. And the temperature change is 36 minus 25 and so we can calculate Delta H for the reaction that takes place.

Explanation:

Answer:

The pressure of O₂ is 0.8 atm.

Explanation:

The pressure exerted by a particular gas in a mixture is known as its partial pressure. So, Dalton's law states that the total pressure of a gas mixture is equal to the sum of the pressures that each gas would exert if it were alone:

PT = PA + PB

This relationship is due to the assumption that there are no attractive forces between the gases.

In this case:

PT=Pnitrogen + Pcarbon dioxide + Pother gases

Being:

and replacing:

PT= 593.4 mmHg + 3 mmHg + 7.1 mmHg

you get:

PT= 603.5 mmHg

Being 760 mmHg= 1 atm, you get:

PT= 603.5 mmHg= 0.8 atm

The pressure of O₂ is 0.8 atm.

Answer:

D. It has a high concentration of OH- ions in solution.

Answer:

The waves are behaving this way due to the simultaneous water drops landing in the water.

Explanation:

because ima smart baddie (≧▽≦)

Answer:

.00402 %

Explanation:

hydrocyanic acid (HCN) is a weak acid with a Ka of 6.17*10^-10 so you need to do a RICE table

initial concentration of HCN is .381 and initial H+ and CN- concentration is 0.

that means the equillibrium concentration of HCN will be (.381-x) and H+ and CN- will be x

put that into the formula for Ka, so it'll be Ka = x^2/(.381-x) and then use quadratic equation to solve. You'll end up getting x = 1.5 * 10^-5.

Then to find percent ionization you solve (concentration of formed ions / initial HCN)

Which will be (1.5 * 10^-5 / .381) * 100 = .00402 % making it a very weak acid <3

Answer:

Explanation:

True

Answer:

250k

I Really This Helps A Little Bit.