Answer:
When 1.20 mole of ammonia reacts, 1.8 moles of water are produced.
Explanation:
The balanced reaction is:
4 NH₃(g) + 5 O₂(g) → 4 NO (g) + 6 H₂O
By stoichiometry of the reaction, the following amounts of moles participate in the reaction:
NH₃: 4 moles O₂: 5 molesNO: 4 molesH₂O: 6 molesThen you can apply the following rule of three: if by stoichiometry 4 moles of ammonia produce 6 moles of water, 1.2 moles of ammonia will produce how many moles of water?
[tex]moles of water=\frac{1.2 moles of ammonia*6 moles of water}{4 moles of ammonia}[/tex]
moles of water= 1.8 moles
When 1.20 mole of ammonia reacts, 1.8 moles of water are produced.
What is the best synonym for "alloy?"
A: nonmetal
B: mineral
C:blend
D:stone
Number 8 plsssssssssss
Answer:
the correct answer is commensalism
Describe how to
separate a mixture of
fillings, sulphur and salt.
Answer:
firstly for separating fillings we should use
magnet for separating it, and we left with sulphur and salt so for this we will use water
when we add water then salt get dissolve in it and we can easily take out sulphur again by evaporation we will obtain salt
hope it helps
GUYS HELP PLS QUICK LOTS OF POINTS AND BRAINLIEST!
A 0.250 M solution was prepared from 135 mL of a 7.00 solution. What volume of water (in mL) was required for dilution?
Answer:
385
Explanation:
0.250m Converted to 250 mL then 250+135+ the answer
I'm not sure?
If you start with 42 g of Fe-53, how much is left after 8.51 minutes? I
Answer:
2:38
Explanation:
Answer:
2.58 good luck with everything
How many moles of HCl can be neutralized by 0.1 liter of 0.5 M NaOH? A. 0.1 B. 0.05 C. 0.5 D. 0.4
Answer:
B. 0.05
Explanation:
The reaction that takes place is:
HCl + NaOH → NaCl + H₂OAs 1 mol of NaOH reacts with 1 mol of HCl, to solve this problem what we need to do is calculate the number of NaOH moles contained in 0.1 liters of a 0.5 M solution:
Molarity = Moles / litersMoles = Molarity * liters0.5 M * 0.1 L = 0.05 molThe moles of Hydrogen chloride required to neutralize the 0.1 liter of 0.5 M Sodium hydroxide is 0.05 moles.
How do we calculate moles?Moles (n) of any substance will be calculated by using the molarity (M) as:
M = n/V, where
V = volume
Given chemical reaction is:
NaOH +HCl → NaCl + H₂O
Moles of 0.5M NaOH will be calculated as:
n = (0.5)(0.1) = 0.05 moles
From the stoichiometry of the reaction it is clear that:
1 mole of NaOH = react with 1 mole of HCl
0.05 mole of NaOH = react with 0.05 mole of HCl
Hence option (B) is correct.
To know more about moles, visit the below link:
https://brainly.com/question/15374113
The brightness of a light correlates to its amplitude. The higher the amplitude, the brighter the light will appear. Which of the waves below depicts the brightest light?
Answer:
Wave X is the brightest light
Explanation:
The amplitude of a wave refers to the maximum upward or downward displacement of a wave from its rest position. This implies that the amplitude is the measured distance from rest position to crest position. Similarly, the amplitude is also measured from the rest position to the trough position.
The crest of a wave is the point on a travelling wave that has the maximum amount of positive or upward displacement from the rest position. The trough of a wave is the point on the travelling wave that has the maximum amount of negative or downward displacement from the rest position.
From the wave diagrams shown in the attachment below, the wave that shows the highest amount of upward or downward displacement from the rest position (x - axis) is wave X. Since the brightness of a light wave increases with increaese in amplitude, wave X will have the highest amount of brightness.
What happens to iron in a bolt as the bolt rusts?
Iron gets converted from Fe2+ to Fe3+ during rusting. Details about rusting can be found below.
What is rusting?Rusting is the deteriorated state of iron or steel as a result of moisture and oxidation.
Rusting is characterized by a reddish-brown color on the surface of the iron.
Rusting is caused by oxidation of iron II (Fe2+) ion into iron III (Fe3+) ion.
Learn more about iron rusting at: https://brainly.com/question/18376414
#SPJ1
Which of the following is a correct description for solids?
A) closely arranged and vibrate in fixed positions
B) closely arranged and can move around
C) closely arranged and in fixed positions
Can you help me Please??
Answer:
C) closely arranged and in fixed positions
how many grams are in 2 moles of copper
Answer:
In 2 moles of copper, there are 319.2172 grams.
Explanation:
Quick conversion chart of moles Copper(II) Sulfate to grams 1 moles Copper(II) Sulfate to grams = 159.6086 grams 2 moles Copper(II) Sulfate to grams = 319.2172 grams
What connects bones and muscles together?
Ligaments
Cartilage
Glue
Tendons
Answer: Tendons.
Explanation: A tendon is a fibrous connective tissue which attaches muscle to bone.
Jane made this picture to represent a chemical reaction:
which of the following statements best explains the type of chemical reaction represented by Jane's picture?
A: it represents a decomposition reaction because the total mass of the product is less than the mass of the reactant
B: it represents a synthesis reaction because one combined reactant forms multiple products
C: it represents a synthesis reaction because the same atoms are present in the reactants and products
D: it represents a decomposition reaction because one reactant breaks apart and forms two products
Answer:
what does the photo look like
Explanation:
Which of the following has the LONGEST wavelength
A.) a lion growling at a frequency of 85 Hz
B.) a bass guitar playing a note at a frequency of 150 Hz
C.) a man speaking at a frequency of 520 Hz
D.) an opera singer singing at a frequency of 2100 Hz
Answer:
D.) an opera singer singing at a frequency of 2100 Hz
Explanation:
Wavelength is inversely proportional to frequency.
The one having the LONGEST wavelength is a lion growling at a frequency of 85 Hz and the correct option is option A.
What is Electromagnetic scale?The electromagnetic spectrum is a range of frequencies corresponding to wavelengths which are a few kilometres to a fraction of the size of an atomic nucleus in the spectrum of electromagnetic waves.
As a wave, light has several basic properties that describe it. One is frequency, which counts the number of waves that pass by a given point in one second.
Another is wavelength, the distance from the peak of one wave to the peak of the next. These properties are closely and inversely related: The larger the frequency, the smaller the wavelength — and vice versa.
A third is energy, which is similar to frequency in that the higher the frequency of the light wave, the more energy it carries.
Therefore, The one having the LONGEST wavelength is a lion growling at a frequency of 85 Hz and the correct option is option A.
Learn more about Electromagnetic spectrum, here:
https://brainly.com/question/23727978
#SPJ2
6. A piece of solid gold was heated from 274K to 314K. 35.73 of energy was needed to raise the temperature.
What mass of gold was present?
From Q = mcΔT, we can rearrange the equation to solve for mass, m = Q/cΔT. The specific heat capacity, c, of solid gold is 0.129 J/g °C. I'm assuming that the energy is given in joules, as it's not specified in the question as written.
m = Q/cΔT = (35.73 J)/(0.129 J/g °C)(40.85 °C - 0.85°C)
m = 6.92 g of gold was present
The heat of the substance depends on the mass, specific heat, and temperature change of the system. The mass of gold that was present was, 6.92 g.
What is mass?Mass of the substance in the thermodynamic system is the ratio of the heat to the product of the specific heat and the temperature change. It is given as,
[tex]\rm m = \rm \dfrac{Q}{c \Delta T}[/tex]
Given,
Heat (Q) = 35.73 J
Specific heat (c) = 0.129 J/g °C
Temperature change = 40 degrees celsius
Mass of gold is calculated as:
35.73 ÷ (0.129) (40) = 6.92 gm
Therefore, 6.92 gms of gold is present.
Learn more about mass here:
https://brainly.com/question/15528502
#SPJ2
what is the wavelength of a photon with an energy of 3.38 x 10-19J?
Answer:
C. 588 nm
Explanation:
Answer:
588 mm
Explanation:
Question is in picture! Will give extra points and BRAINLIEST! Promise!!! No links or I will report. Make sure it’s a legitimate answer and not a link
Can someone answer this pls
Answer:12
Explanation:
how do i open the link when i get a question answered
Answer:
Just click on the answer, if it is an external link DO NOT CLICK IT. it may contain dangerous stuff including h*cked stuff.
Explanation:
Gas density can be calculated by dividing the mass of gas by its volume. If you took a balloon of gas and then warmed the balloon in a sunny window, what can now be said about the density of the gas in the balloon? Gas density can be calculated by dividing the mass of gas by its volume. If you took a balloon of gas and then warmed the balloon in a sunny window, what can now be said about the density of the gas in the balloon? The gas density will decrease. The gas density will remain the same. The gas density will increase. The density of gases is independent of temperature. none of the above
Answer: The density will decrease
Explanation: Heating a substance causes molecules to speed up and spread slightly further apart, occupying a larger volume that results in a decrease in density.
How does the structure of Ethane (C2H6) and Propane(C3H8) differ? Are they members of a Homologous series?
Answer:
Ethane & propane are members of same homologous series : alkane which is indicated with Cn H2n+2
Explanation:
what's different between fat molecules and carbohydrate and protein molecules
Answer:
ddwadadadadwd
Explanation:
Does somebody know the answer ?
How do you account for the formation of ethane during chlorination of methane
Answer:
ethane is formed due to side reaction
Explanation:
During chlorination of methane, ethane is formed due to side reaction in termination step by the combination of two methyl free radicals.
Answer:
During chlorination of methane, ethane is formed due to side reaction in termination step by the combination of two methyl free radicals.
How many rings (energy levels) will an atom with 12 electrons have?
Answer:
3
Explanation:
from the KLMN shell
K has the maximum of 2 electrons
M has the maximum of 8
M has the maximum of 18
so 12 electrons fell on M shell which is the third one
that's all....have fun
Calculate the molar mass
Answer:
52
Explanation:
Why is it important to predict consequences when decision-making?
A.Considering the consequences can help you pick the option with the best outcome.
B.Predicting consequences isn’t a step in the decision-making process.
C.There usually aren’t any consequences when making decisions.
D.Consequences won’t help you make a decision.
mes.
monthly
(Chp.3)
(40) The difference of squares of two numbers is 180. The square of the smaller number is 8 times the larger number. Find
the two numbers.
The difference of squares of two numbers is 180. The square of the smaller number is 8 times the larger number. Find the two numbers.
Solution:-Let the larger number be x
And, the square of the smaller number be 8x
ATQ ,x² − 8x = 180
⇒ x² − 8x − 180 = 0
⇒ x² − (18 − 10)x − 180 = 0
⇒ x² − 18x + 10x − 180 = 0
⇒ x (x − 18) + 10(x − 18) = 0
⇒ (x − 18) (x + 10) = 0
⇒ x − 18 = 0, x + 10 = 0
⇒ x = 18, x = −10
⇒ x = −10, 18
[tex] \therefore [/tex] Either, x = −10 and x = 18
x = 18 (Positive value)
Now, the square of the smaller number = 8x = 8 × 18 = 144
So, the square of the smaller number = [tex]\sqrt{144} [/tex] = 12
The two numbers are 18 and 12. [Answer]An ideal gas is held in a rigid container at temperature of 201∘C. Upon cooling the gas, the pressure decreases by a factor of 2.0, while the volume and the amount of gas remain constant. What must be the final temperature of the gas?
Answer:
237 K
Explanation:
Given that,
Initial temperature, T₁ = 201⁰C = 474 K
Let P be the initial pressure. Upon cooling the gas, the pressure decreases by a factor of 2.0, while the volume and the amount of gas remain constant.
Final pressure = P/2
The relation between the pressure and temperature is as follows :
[tex]\dfrac{P_1}{P_2}=\dfrac{T_1}{T_2}[/tex]
Put all the known values,
[tex]\dfrac{P}{\dfrac{P}{2}}=\dfrac{474}{T_2}\\\\2=\dfrac{474}{T_2}\\\\T_2=\dfrac{474}{2}\\\\T_2=237\ K[/tex]
So, the final temperature of the gas is equal to 237 K.
PLEASE ITS A TEST !!!!!!!! HELPPP!!!!!
the element chlorine is a gas. it's formula is cl2 . how many different masses of the cl2 molecule would you expect to find in a sample of chlorine gas ? explain your answer
Answer:
the answer is 3.33⋅1023 molecules of Cl2. Note that 6.022⋅1023 is also known as Avogadro's number, and it can be referred to as the number of molecules in one mole of that substance. Also, I calculated 70.9 because 35.45 g/mol (the mass of one Chlorine atom) times 2 is 70.9 g/mol (Cl2 has two Chlorine atoms).
Explanation: