Question 1 (4 points)
Using the 4 pictures below, write a lab safety rule that could go with EACH of the pictures. You should have 4 rules in total (one for each picture)

The carbon atoms are sp3 hybridized.

Hope this helps!

Heat required is mcΔT=100×0.39×50=1950 J

Solve any question of Thermodynamics with:-

The specific heat of the substance that requires 270 J of energy to raise the temperature is 2.57 J/g⁰C.

The specific heat capacity of the substance is calculated as follows;

Q = mcΔФ

where;

c = Q/mΔФ

c = (270) / (4.2 x 25)

c = 2.57 J/g⁰C

Thus, the specific heat of the substance that requires 270 J of energy to raise the temperature is 2.57 J/g⁰C.

Learn more about specific heat here:  https://brainly.com/question/21406849

#SPJ2

This question is mentioning an experiment that is not being described about the volume of the propane gas in an Erlenmeyer before the addition of water.

In this case, since no information is given, it is possible to propose a suggested procedure of how to figure it out via gas laws, specifically, the ideal gas one, since no change is decribed before the addition of water:

[tex]PV=nRT[/tex]

Thus, you can solve for the volume, by dividing both sides by the pressure, so that you will get:

[tex]V=\frac{nRT}{P}[/tex]

Now, to ensure a correct calculation, make sure you have the moles (divide by the molar mass of propane, 44,1 g/mol, if you were given the grams), the temperature in K (add 273.15 if you have degree Celsius), the ideas gas constant as 0.08206 and the pressure in atm, in order to have consistent units.

If you need the volume in milliliters, you will need to multiply the previous answer by 1000 in order to perform the appropriate conversion.

Learn more:

Answer:

Explanation:

Oxidation reaction

The kind of reaction involving the transfer of electrons or hydrogen away from a molecule is called oxidation.

In the same vein, the molecule that receives the electron or the hydrogen atom is said to be reduced. This means that oxidation cannot exist in isolation without reduction.

In other words, oxidation is defined as:

While reduction is defined as:

More on oxidation/reduction reactions can be found here: https://brainly.com/question/3867774

Answer:

A team led by Michaël Gillon at the University of Liège in Belgium detected the planets using transit photometry with the Transiting Planets and Planetesimals Small Telescope (TRAPPIST) at the La Silla Observatory in Chile and the Observatoire de l'Oukaïmeden in Morocco.

Explanation:

This is just how the TRAPPIST system was discovered.

Here's the link about the information you need:

https://www.nasa.gov/press-release/nasa-telescope-reveals-largest-batch-of-earth-size-habitable-zone-planets-around

A: activation energy

hope i helped :D

The very dark soils samples that contain the highest amounts of carbon and nitrogen is loamy soil.

Soil is the outermost portion of the earth's crust on which plants grow. The appearance of a soil sample gives an idea of the type and nature of the soil it is.

We are told that two out of the six soil samples gathered are very dark and contains an enormous amount of carbon and nitrogen. These two must be samples of loamy soil.

Learn more: https://brainly.com/question/17638582

Answer:

Explanation:

Decreases

Answer:

Hydrogen ions decrease. It reduces the concentration of ions.

Explanation:

Answer:

Reaction: Al2(SO4)3 + 3BaCl2 --> 2AlCl3 + 3BaSO4

Type: Double Replacement

Explanation:

1.) First you need to understand what the different reactions are

a.) Synthesis: is a reaction where two or more substances will combine with each other to make one product.

          Ex:  A + B → AB

b.) Decomposition: when one compound breaks down into two or more substances. (Opposite of synthesis)

          Ex:  AB → A + B

c.) Single Replacement: when one element replaces another one in a reaction

          Ex:  A + BC → AC + B

d.) Double Replacement: when the positively charged cations and negatively charged anions of the reactants trade places. Normally this will be the two outer elements combining and the two inner ones combining.

          Ex: AB + CD →  AD + CB

e.) Combustion: when a substance reacts with oxygen gas and releases energy as light and heat.

         Ex: CH4(g) + 2 O2(g) → CO2(g) + 2 H2O(g)

2.) From there you can write out the formula of the different reactants and products and balance the equation.

Answer:

When salt is dissolved in water, the particles of salt get into the spaces between particles of water and starts dissolving and disappear.

Explanation:

Answer:

c.) feeling the heat from a lightbulb with your hand when touching the bulb

Explanation:

In heat transfer by conduction, feeling the heat from a lightbulb with your hand when touching the bulb will be categorised as the best condition.

Answer:

Helium is less dense. Because helium is lighter than air, a helium balloon rises, just as an air bubble rises in more dense water

Explanation:

Also why not. It just is.

Answer:

This is due to the fact that helium has a lower density. A helium balloon rises like an air bubble in more dense water because helium is lighter than air. Another gas lighter than air is hydrogen, which is even lighter than helium.

Explanation:

Answer:

The answer is subdivided,created or destroyed

Answer:

3.)Saturated

Explanation:

it was saturated and then turned super saturated

Answer:

Yes.

Explanation:

Bath bombs are usually made from three key ingredients: baking soda, citric acid and cornstarch, said Frankie Wood-Black, an instructor in chemistry at Northern Oklahoma College and an experienced bath-bomb maker. Often, bath bombs also include dyes and perfumes, and sometimes they have epsom salt.

Answer: yes

Explanation:

After beginning the experiment with a saturated solution, then increasing the heat, we will be left with an unsaturated solution.

To obtain the saturated solution, we must dissolve sugar in the water. We can say that the solution has become saturated when the solution is no longer able to dissolve more sugar. It has reached its capacity for the solute that it can dissolve in these conditions.

However, the temperature of a solution has an effect on the dissolving limit of the solution. That is, when a solution is heated it becomes able to dissolve more solute. Therefore, if we were to heat a saturated solution, it will be able to dissolve more solute and therefore will no longer be at its limit, meaning it is no longer a saturated solution. It has become unsaturated.

To learn more visit:

https://brainly.com/question/3035198?referrer=searchResults

The rearrangement produces a more stable tertiary carbocation and the unexpected product.

In the image shown, the substrate is 1-cyclobutylethene. The attack of H2SO4 and water will lead to the conversion of the alkene to an alkanol. Two possible products may be obtained with one being greater than the other.

The unexpected product (Shown in the image attached) is obtained due to rearrangement of the carbocation intermediate. The rearrangement produces a more stable tertiary carbocation and the unexpected product.

Learn more: https://brainly.com/question/6284546

Answer:

Chlorine is a halogen and sodium is an alkali metal.

Explanation:

[tex] \huge \mathbb \pink{ANSWER:}[/tex]

Explanation:

Hope it helps ^•^

Each shell can contain only a fixed number of electrons: The first shell can hold up to two electrons, the second shell can hold up to eight (2 + 6) electrons, the third shell can hold up to 18 (2 + 6 + 10) and so on. The general formula is that the nth shell can in principle hold up to 2(n2) electrons

Answer:

Refer to the periodic table to do this.

Explanation:

1. Na, K, Cs Fr, Rb

  Sodium, Potassium, Cesium, Francium, Rubidium

  3, 4, 6, 7, 5

Ascending order: Na, K, Rb, Cs, Fr

2. Ca, Sr, Ba, Ra, Mg

   Calcium, Strontium, Barium, Radium, Magnesium

   4, 5, 6, 7, 3

Ascending Order: Mg, Ca, Sr, Ba, Ra

When doing the electronic configuration of the elements, count how many number of divides it has. For example, Na(Sodium) has 11 electrons and it is divided like this: 2,8,1. So it divides into 3 parts so there will 3 shells for sodium.

Hopefully this helps!!

The final temperature of the cup may be less than accurate thereby affecting the entire results of the experiment carried out using the cup.

A styrofoam cup is an insulated material. A styrofoam cup prevents heat gain or looses from the cup. Heat is gained by the water inside the styrofoam cup. The cup prevents exchange of energy with the environment.

When water is lost from the styrofoam cup, the final temperature of the cup may be less than accurate thereby affecting the entire results of the experiment carried out using the cup.

Learn more:  https://brainly.com/question/8646601

Answer:

BeF2

Explanation:

The correct chemical formula for the product of the reaction when beryllium and fluorine combine is BF₂.

The valence electron of an atom determines how an atom goes into bonding.

Beryllium(Be) has 4 electron and has 2 valence electron. To fulfil the octet rule, it can easily give out this 2 electron during bonding.

Fluorine(F) has 9 electrons and 7 valency electrons. To fulfil the octet rule, it readily accepts a single electron.

The correct chemical formula for the product of the reaction when beryllium and fluorine combine is BF₂.

This means 1 atom of beryllium combines with 2 atoms of fluorine to form beryllium fluoride. The beryllium give its 2 valency electrons to the 2 atoms of fluorine. The 2 atoms of fluorine will now have a valency electron of 8 each. The octet rule has been fulfilled at this point.

read more: https://brainly.com/question/24702809?referrer=searchResults

The list which includes only bulk properties of matter is: C. boiling point, surface tension, vapor pressure.

What is matter?

Matter can be defined as anything that has mass and can occupy space.

Thus, any physical object or substance that is found on planet Earth is typically composed of matter.

The three (3) states of matter:

Since all matter are made up of atoms, they have a property of existing in three (3) distinct states and these include;

A bulk property of matter refers to the property that affects matter as a whole and they are listed as follows:

1. Stress

2. Strain

3. Elasticity

4. Boiling point

5. Surface tension

6. Vapor pressure

In conclusion, the other list of properties are not a bulk property of matter.

Find more information on matter here: https://brainly.com/question/17203857

Answer:

Solid

Explanation:

Answer:

the rock layer is at least 248 million years old

Explore

Answer:

May I assume "ethanol acid is just ethanol (it has one slightly acidic H atom).  If so, the molar mass is 46.02 g/mole.

Explanation:

We have 30 cm^3 [30 ml] of 1.0 M (1 mole/liter)  [1 dm³ = 1 liter].

That is 1 mole/liter.  30 ml would contain (0.030 liter)*(1 mole/1 liter) = 0.03 moles.