What is the freezing point, in Celsius, of a sucrose-water solution containing 2.23g sucrose per 100g water. The molal freezing point depression constant for water is 1.86oC/m.

Answer:

Initial rate experiments

The simplest initial rate experiments involve measuring the time taken for some recognizable event to happen early in a reaction. This could be the time required for 5 cm3 of gas to be produced, for a small, measurable amount of precipitate to form, or for a dramatic color change to occur. Examples of these three indicators are discussed below.

The concentration of one of the components of the reaction could be changed, holding everything else constant: the concentrations of other reactants, the total volume of the solution and the temperature. The time required for the event to occur is then measured. This process is repeated for a range of concentrations of the substance of interest. A reasonably wide range of concentrations must be measured.This process could be repeated by altering a different property.

Explanation:

I don't think so if this is the answer. if not ok sorry

Based on our knowledge of strong and weak acids, we can confirm that the Ka value for acetic acid will be relatively low since it is a weak acid.

Acids can be strong or weak. This is determined by its tendency to break apart into ions or stay together to form molecules. Although somewhat counter-intuitive, strong acids are those that are most likely to break apart and therefore contain a high number of ions within their solutions.

Weak acids, on the other hand, are those that tend to stay together in the form of molecules and therefore possess very low ion counts in their solutions. The acid dissociation constant, Kₐ, is used to measure whether an acid is weak or strong and how much so. In the case of Acetic acid, the ka measurement will offer a low value, indicating a weak acid.

To learn more visit:

https://brainly.com/question/4131966?referrer=searchResults

Answer:315 - 282 = 173?

Explanation:

Answer:

oxygen (O2 )

Explanation:

This problem is describing the equilibrium whereby hydrofluoric acid decomposes to hydrogen and fluorine gases at 298 K whose equilibrium constant is 8.70x10⁻³, the equilibrium concentrations of all the reactants are both 1.33x10⁻³ M and asks for the initial concentration of hydrofluoric acid which turns out to be 2.86x10⁻³ M.

Then, we can write the following equilibrium expression for hydrofluoric acid once the change, [tex]x[/tex], has taken place:

[tex][HF]=[HF]_0-2x[/tex]

Now, since both products are 1.33x10⁻³ M we infer the reaction extent is also 1.33x10⁻³ M, and thus, we can calculate the equilibrium concentration of HF via the law of mass action (equilibrium expression):

[tex]8.70x10^{-3}=\frac{(1.33x10^{-3} M)^2}{[HF]} }[/tex]

[tex][HF]=\frac{(1.33x10^{-3} M)^2}{8.70x10^{-3}} }=2.03x10^{-4}M[/tex]

Finally, the initial concentration of HF is calculated as follows:

[tex][HF]_0=[HF]+2x=2.033x10^{-4}+2*(1.33x10^{-3})=2.86x10^{-3}M[/tex]

Learn more:

Answer:

H3PO4 + 3KOH--------->  K3PO4 + 3H2O

Explanation

H3PO4 + KOH------------> K3PO4 + H20

when an hydrogen ion containing acid (HX) reacts with a hydroxide containing base(BOH)  they produce water and a "salt".

water can be called  dihydrogen oxide (H2O), but it can also be called

hydrogen hydroxide (HOH)...same thing.

so the phosphoric acid (H3PO4) contains 3 hydrogen ions (H), and needs 3

hydroxide ions to from 3 hydrogen hydroxides .. that is 3 waters AND A "SALT" WITH THE REMAINING SPECIES ( K AND PO4)      

so let us balance

H3PO4 + 3KOH--------->K3PO4 + 3HOH  or

H3PO4 + 3KOH--------->  K3PO4 + 3H2O

Check:

6 H on the left side, 6 H on the right side

1 P on the left side, 1 P on the right side

3 K on the left side, 3 K on the right side

7 O on the left side, 7 O on the right side

abadabaabdabadaba........that's all folks

yup it is balanced

Answer:

Direct-air capture

Explanation:

To understand the technology I'm about to explain, I'll model it to something familiar. As you know, the process of  photosynthesis is where trees and plants use sunlight, water, and carbon dioxide to create energy for themselves, and release oxygen as a byproduct. Direct- air capture is exactly like this. Its pulls in air and then through a range of similiar chemical reactions, it extracts the carbon dioxide from it while returning the rest of the air to the surrounding environment. Except, the Direct-air capture does this at a much faster rate than nature does. The direct-air capture uses a ginormous fan that pulls air in which then passes over plastic surfaces that have potassium hydroxide solutions covered over them. The potassium hydroxide solution chemically binds with the carbon dioxide molecules, removing them from the air and trapping them in the liquid solution as a carbonate salt. The carbon dioxide is then contained where it is compressed and purified and then stored for later use.

Answer:

Ionization enthalpy

Explanation:

that should be right

two layers of different liquids=two phases.

Because oil doesn't dissolve in water. It only floats on water.

- BRAINLIEST answerer

My classmate's statement in incorrect because plants are also composed of cells.

All living things are composed of cells. A cell is the smallest unit of living organisms. Cells obtain energy via the process of cellular respiration. During cellular respiration, glucose is broken down to yield carbon dioxide and water.

In photosynthesis, carbon dioxide and water are combined to form glucose. The two processes are opposites of each other. Plants produce their own food via photosynthesis. Since plants are composed of cells, plant cells also undergo cellular respiration therefore my classmate's statement in incorrect.

Learn more: https://brainly.com/question/11324711

According to the equation given, we have N2 + 3H2 → 2NH3.

Therefore, to determine the moles of NH3 we have to do the following-

1.3 mol H2 × 2 mol NH3 / 3 mol H2 = 0.87 mol

Answer: .87 moles of NH3 are produced from 1.3 moles of H2.

I hope this helps!

Spontaneous processes are processes such as;  a soluble salt dissolves when it is mixed with water, iron rusts when it exposed to salty water and a match continues to burns after it is lit.

A spontaneous process is a process that occurs without external input of energy or does not require a continuous input of energy once the process has gotten underway.

Among the options the processes which are spontaneous under standard conditions of 1 atm, 298 K and 1 M are;

Learn more: https://brainly.com/question/6505878

Answer:

Atoms themselves do not have a smell. Molecules do.

Explanation:

What happens is that particular molecules bind to receptors in our nose, activating nerves, that then send signals to our brain, which we then interpret and perceive as “smells”. Different molecules bind to different receptors, which is why we can perceive a number of different smells

Explanation:

Oils are made up of long hydrocarbon chains which are non polar. Since water is a polar solvent oil doesn't dissolve in water well.( Polar solutes dissolve in polar solvents and non polar solutes dissolve in non polar solvents) The hydrocarbon chains are hydrophobic.

Answer:

The Nucleus...

it perform many activities and stores DNA in a cell.

Answer:The plates are not fixed but are constantly moving atop a layer of solid and molten rock called the mantle. The Ring of Fire is a string of volcanoes and sites of seismic activity, or earthquakes, around the edges of the Pacific Ocean. ... A hotspot is a place in the middle of a tectonic plate where hot magma rises.

Explanation:

Answer:

First, both ingredients are excellent at dissolving tough grime. However, vinegar alone will simply run off of most surfaces, while dish soap is too thick to use as a spray. But when you mix them together, you get an effective, sprayable cleaner that sticks to any surface!

A cylindrical weight with a mass of 3 kg is dropped onto the piston from a height of 10 m. The entropy of the gas is 1.18 J/K and the change in the entropy of the environment is -1.18 J/K.

A cylindrical weight with a mass (m) of 3 kg is dropped, that is, its initial velocity (u) is 0 m/s and travels 10 m (s). Assuming the acceleration (a) is that of gravity (9.8 m/s²). We can calculate the velocity (v) of the weight in the instant prior to the collision with the piston using the following kinematic equation.

[tex]v^{2} = u^{2} + 2as = 2 (9.8 m/s^{2} ) (10m) \\\\v = 14 m/s[/tex]

The object with a mass of 3 kg collides with the piston at 14 m/s, The kinetic energy (K) of the object at that moment is:

[tex]K = \frac{1}{2} m v^{2} = \frac{1}{2} (3kg) (14m/s)^{2} = 294 J[/tex]

The kinetic energy of the weight is completely converted into heat transferred into the gas cylinder. Thus, Q = 294 J.

Given all the process is at 250 K (T), we can calculate the change of entropy of the gas using the following expression.

[tex]\Delta S_{gas} = \frac{Q}{T} = \frac{294 J}{250K} = 1.18 J/K[/tex]

The change in the entropy of the environment, has the same value but opposite sign than the change in the entropy of the gas. Thus, [tex]\Delta S_{env} = -1.18 J/K[/tex]

A cylindrical weight with a mass of 3 kg is dropped onto the piston from a height of 10 m. The entropy of the gas is 1.18 J/K and the change in the entropy of the environment is -1.18 J/K.

Learn more: https://brainly.com/question/22655760

Answer:

Na2S

Explanation:

hope this helps

Answer:

You are not showing the question, but I believe the answer is cis-3,4-dimethyl-3-hexene.

Explanation:

since the substituents are on same side, it call cis. Followed by the name.

Answer:

Meiosis produces haploid cells (gametes), which contain single chromosomes, or on-half the number of chromosomes in diploid cells. When a sperm and an egg join, the single chromosomes pair up, which results in genetic diversity in the offspring

Answer:i think its d not sure tho

Explanation:

The solubility of nitrogen gas in water is 1.90 mL/dL at 1.00 atm and 13.3 mL/dL at 7.00 atm.

We want to relate the solubility of a gas with its partial pressure.

We can do so using Henry's law.

Henry's law states that the amount of dissolved gas in a liquid is proportional to its partial pressure above the liquid.

C = k × P

where,

The solubility of nitrogen gas is 1.90 mL/dL of blood at 1.00 atm.

Since the solvent is basically water, we can understand that the concentration of nitrogen gas is 1.90 mL/dL at 1.00 atm.

We can use this information to calculate Henry's Law constant.

k = C/P = (1.90 mL/dL)/1.00 atm = 1.90 mL/dL.atm

We want to calculate the solubility of nitrogen gas at a pressure of 7.00 atm.

We will use Henry's law.

C = k × P = (1.90 mL/dL.atm) × 7.00 atm = 13.3 mL/dL

The solubility of nitrogen gas in water is 1.90 mL/dL at 1.00 atm and 13.3 mL/dL at 7.00 atm.

Learn more about solubility here: https://brainly.com/question/11963573

Answer:

what's the question?

Explanation:

I'll help

Air resistance opposes the gravity in a falling object hence the object loses speed once it reaches terminal velocity.

According to the experiment of Galileo, in the absence of air resistance, all objects that are thrown down from the same height will hit the ground at he same time due to the effect of gravity.

We know that the air resistance makes the acceleration of object to become less than the acceleration due to gravity. So, air resistance opposes the force of gravity and causes falling objects to lose speed once they reach terminal velocity.

Learn more: https://brainly.com/question/865531

Answer:

The answer is D - Air resistance opposes the force of gravity and causes falling objects to lose speed once they reach terminal velocity.

Ill explain why -, for example ,

When the paper is smooth, it exposes a large surface to the air beneath it which slows its descent. Once it is crumpled, the surface which comes in contact with the air is much smaller, allowing it to fall much faster.  At first, you probably thought the book would touch the ground first since it is heavier However, once the piece of paper was crumpled, they hit the ground at the same time! Funny, since it is the same piece of paper and the book is still heavier. It all comes down to form. I hope this helped u with the test !!

Answer:

42.0g/mol

Explanation:

The steps for this question is to use the ideal gas law, and then use n=m/M to find molar mass.

PV = nRT

n= PV/RT

Change 23 degrees to 296.15 K and 684mmHg to kpa

n = (91.1925kpa)(2.00L)/(8.314Lkpa/mol K)(296.15K)

n= 0.074mol

n = m/M

M = m/n

M = 41.98489g/mol

Answer:

c

c

c

c

c

c

c

c

c

c

c

c

c

c

c

c

cc

c

c

c

c

c

c

c

c

c

ccc

c

c

c

c

c

c

c

c

c

c

c

c

c

c

c

c

c

cc

c

c

c

AMOUNG US AND THE ANSWER IS C

Explanation:

Answer:

its c

Explanation:

Answer:

from the words below underline six example of rhetorical patterns