what is the magnitude of the torque that the axle must apply to prevent the disk from rotating?

Answer:

.............................

Answer:

Earth because of greater gravity

Answer:

I am not quite sure....

Explanation:

Explanation:

basically i, say the answer is w

Hi there!

If we sum the forces acting on the bucket:

∑F = T (upward) - Mg (downward)

Thus:

ma = T - mg

We can rearrange for T:

ma + mg = T

Plug in the given values:

4.6(3 + 9.8) = T = 58.88 N

Answer:

Explanation:

Ruler. A steel ruler aids the measurement and layout of straight lines. The ruler, also called "straightedge" or "straight-edged ruler," is a long, thin strip of wood, metal or plastic marked with increments of measurement.

Measuring Tape. The modern measuring tape's roughly palm-sized casing contains a coiled strip of metal marked with increments of measurement. The metal strip, called "tape," attaches to a spring which automatically retracts the tape into the casing following use.

Walking Tape Measure. The walking tape measure, also called "surveyor's measure," records the distance traveled by a wheel. An operator pushes the measure's wheel, similar to a bicycle wheel, by a handle as an attached ticker box displays feet or meters in the same format as a car's odometer.

Laser Measure. The laser measure offers point and shoot distance measurement. In its most basic form, a laser measure is a hand-held electronic device with a digital display.

The definition of the center of mass allows to find the result for the position of the mass center of more than the H₂O molecule is;

         [tex]x_{cm} = 0 \ and \ y_{cm} = 6.9 10^{-3 } nm[/tex]  

the concept of center of mass of a system is the point where external forces are applied, it is given by the expression

             [tex]\frac{x}{y} =\frac{1}{M_{total}} \sum m_i r_i[/tex]  

Where M is the total mass of the systemr_i and m_i sums the position and masses of the element i of the system

In the attachment we have a diagram of the system where the axis and coordinates of the molecules are shown, in this case it is indicated that the origin is in the oxygen atom, so its distance is zero.

           [tex]r_{cm} = \frac{1}{2 m + M} \ (2 m r )[/tex] )

They indicate the mass of the hydrogen atom m = 1.008 amu, the bond length r = 0.103 nm and there is an angle 106º between the two hydrogens, therefore the angle from the vertical is:

           θ = 106/2 = 53º

Let's find the position of the center of mass for each axis.

x-axis

           [tex]x_{cm} = \frac{1}{2m+ M} \ ( m x_1 - m x_2)[/tex]  

y-axis

          [tex]y_{cm} = \frac{1}{2m + M} \ ( m y_1 + m_2)[/tex]

Let's use trigonometry to find the components of the bond length.

         cos θ = [tex]\frac{y}{L}[/tex]  

         sin θ = [tex]\frac{x}{L}[/tex]  

         y = L cos θ

         x = L sin θ  

We substitute.

          [tex]x_{cm} = \frac{1}{2m+M} \ (mL (sin 53 + sin (-53)) \\y_{cm} = \frac{1}{2m + M} \ ( mL cos 53 + mL sin 53)[/tex]

we use.  

          sin θ = - sin -θ

          cos θ = cos -θ

Let's calculate.

        [tex]x_{cm} = 0 \\y_{cm} = \frac{1}{2 \ 1.008 + 15.9999} \ ( 2 \ 1.008 \ 0.103 cos 53)[/tex]

We see that the center of mass is on the x axis and at a distance from the y-axis of 6.9 10-3 nm

In conclusion using the definition of the center of mass we can find the result for the position of the center of mass of the H₂O molecule is;

          [tex]x_{cm}=0[/tex]  and [tex]y_{cm}[/tex]cm = 6.9 10⁻³ nm

Learn more here: brainly.com/question/8662931

Answer:

a)object is in uniform motion

Explanation:

velocity is constant.and a=0

body is in uniform motion.

BRAINLIST PLS

Answer: Pressure is proportional to force and inversely proportional to area.

Explanation:

Just divide the both, you will get the answer!

does it sound rude?

im sorry for that!

Answer:

10

Explanation:

Answer:

25A°C=2L

35A°C=? More

=35/25×2L

=7/5×2L

=14L/5

=2.8L

Answer:

Rocks from early Earth that contained copper are red in color

Explanation:

"Copper, a red mineral, reacts with oxygen to form a green-colored compound. In early years, rocks containing copper were red. This fact shows that there was no oxygen in the early atmosphere to oxidize red copper into the green-colored compound."

Answer:

combine them all

6 m

Explanation:

Answer:

72n

Explanation:

Hi there!

We can first find the angular displacement of the first 20 seconds by finding the angular acceleration.

Begin by converting 120 rev/min to rev/sec:

120 rev/min × 1 min/60 sec = 2 rev/sec

ω = αt

2 = 20α

α = 0.1 rev/sec²

θ = ωit + 1/2αt²

The fan starts from rest, so:

θ = 1/2αt²

θ = 1/2(0.1)(20²) = 20 revolutions

Now, for the next 40 seconds, we can find the fan's deceleration:

ωf = ωi + αt

0 = 2 + αt

-2 = 40α

α = -0.05 rad/sec²

Use the above equation:

θ = ωit + 1/2αt²

θ = 2(40) + 1/2(-0.05)(40²) = 80 - 40 = 40 rev

θ = 4800 - 2400 = 2400 revolutions

Add the two:

θtotal = 20 + 40 = 60 revolutions

Force of air and gravitational force are acting on the ball when launched from the slingshot.

When a ball is launched from a slingshot, during its travel force of air as well as gravitational force are acting on the ball because there is air which moves opposite to the motion of a ball whereas the force of gravity attracts the ball downward.

The force of air slows down the motion of the ball while on the other hand, the force of gravity brings the ball to the ground due to attraction. If these two forces are not present then the ball continues its motion forever so we can conclude that force of air and force of gravity are acting on the ball when launched from the slingshot.

Learn more: https://brainly.com/question/25533186

Answer:

675 KM

Explanation:

hAVE A NICE DAY

Answer:

6.5

Explanation:

Because 1.5+5=6.5

Answer:

66,000J

Explanation:

Mechanical energy = Gravitational energy + Kinetic Energy

ME = 6,000 + 60,000 = 66000 J

(a) Since the charge at any point inside sphere is zero.

by Gauss law,E=0.

(b) Just outside, E=q/4πϵ  o ​  r  2   so, E=10  5  NC  −1  

(c) q=1.6×10  −7 C r=18 cm E=q/4πϵ  o  r  2 E=4.4×10  4  NC  −1

Answer:

57.97m/s

12.1s

Explanation:

Use one of the key equations of accelerated motion and sub in the values

vf^2=vi^2+2aΔd

vf^2=(20)^2+(2*9.8)(150)

vf^2 = 3340

vf = 57.79m/s (square rooted both sides)

now use another equation

Δd = (vi+vf/2)Δt

and rearrange for Δt

Δt = (2Δd-vf)/vi

sub in values

Δt = (2*150-57.79)/20

Δt = 12.1s

mark me as brainliest if this helped!

[tex]\text{Given that },\\\text{Mass, m = 6 kg}\\\\\text{Acceleration, a = 6 } \text{m} \text{s}^{-2}\\\\\text{Time, t=9 sec}\\\\\text{Displacement, }s=ut + \dfrac 12 at^2 = \dfrac 12 at^2 = \dfrac 12 \times 6 \times 9^2 = 243 ~m}\\\\\ \text{Work,} ~W = Fs = mas = 6 \times 6 \times 243 = 8748 ~ J}[/tex]

Hi there!

We know that:

[tex]W = \Delta KE = \frac{1}{2}m(\Delta v)^2[/tex]

We can begin by solving for the final velocity using the equation:

[tex]v_f = v_i + at[/tex]

The box starts from rest, so:

[tex]v_f = at\\\\v_f = 6(9) = 54 m/s[/tex]

Now, we can find the kinetic energy:

[tex]KE = \frac{1}{2}mv^2\\\\KE = \frac{1}{2}(6)(54^2) = 8748 J[/tex]

Thus:

[tex]W = \Delta KE\\\boxed{W = 8748 J}[/tex]

Answer:

stored Energy = Power x time = 65 x 25x 60 = 105.6 Kjoules

In a radio frequency identification (RFID) system, the unique data identifying an item are typically found in: tags.

What is an RFID system?

RFID is an acronym for radio frequency identification.

A RFID system can be defined as an automatic, wireless, identification technology (device) that is typically designed to allow end users store and retrieve information, especially through the use of an electromagnetic field.

The operational benefits of an RFID system:

Generally, a radio frequency identification (RFID) system is used for the following:

1. To identify an item or individual.

2. To trace and tracking an item or individual.

3. To track an item or individual.

The components of an RFID system:

An RFID system is a wireless, identification technology (device) that comprises two (2) main components and these are:

Tags refer to small objects containing an antenna and a chip (smart barcodes) that are used to automatically identify an item or individual they are embedded in or attached to.

In conclusion, the unique data that are used in identifying an item are typically found in tags.

Read more on RFID tags here: https://brainly.com/question/24167692

Answer:

Sunspots are places where the strong magnetic fields in the Sun resist the upward motion of bubbling hot gases from underneath

Explanation:

Answer:

10cm

Explanation:

25/20=x/8

cross multiply;

200=20x

x=10

Answer:

As per the Hooke's Law, if spring is stretched, the force exerted is proportional to the increase in length from the equilibrium length. The formula to calculate the spring constant is as follows: k= -F/x, where k is the spring constant. F is the force and x is the change in spring's length.

Answer: Levers

Explanation: Levers lifte

the machines arm

The force required to start the block in motion is equal to 39.2 Newton.

Given the following data:

To determine the force required to start the block in motion:

Note: The force that is required to start the block in motion must be greater than or equal to the force of static friction.

Mathematically, the force of static friction is given by the formula;

[tex]Fs = uFn = umg[/tex]

Where;

Substituting the given parameters into the formula, we have;

[tex]F_s = 0.4 \times 10 \times 9.8\\\\F_s = 4 \times 9.8\\\\F_s = 39.2\;Newton[/tex]

Read more on force of static friction here: https://brainly.com/question/25686958