When hydrogen peroxide (H2O2) is used in rocket fuel, it produces water and oxygen (O2): Can someone help with parts B and C?

Answer:

The sun provides more than enough energy to meet the whole world's energy needs, and unlike fossil fuels, it won't run out anytime soon. As a renewable energy source, the only limitation of solar power is our ability to turn it into electricity in an efficient and cost-effective way.

Answer:

[tex]m_{N_2}=93.3gN_2[/tex]

Explanation:

Hello there!

In this case, for this stoichiometry-based problem, it is firstly necessary to realize that the decomposition of ammonium dichromate is given by:

[tex](NH_4)_2Cr_2O_7(s)\rightarrow N_2(g)+4H_2O(l)+Cr_2O_3(s)[/tex]

Thus, since the mole ratio between ammonium dichromate and the gaseous nitrogen (molar mass = 28.02 g/mol) is 1:1, we can compute the produced mass of the latter via stoichiometry as shown below:

[tex]m_{N_2}=3.33mol(NH_4)_2Cr_2O_7*\frac{1molN_2}{1mol(NH_4)_2Cr_2O_7}*\frac{28.01gN_2}{1molN_2}\\\\ m_{N_2}=93.3gN_2[/tex]

Best regards!

Answer:

The strength of the field varies depending on its location around the magnet. The magnetic field of a bar magnet is strongest at either pole of the magnet. It is equally strong at the north pole when compared with the south pole.

Explanation:

Answer:

There is too much here for me to attempt in one sitting, but I will get you started and give suggestions that may help you proceed on your own.

a)  As far as I can tell, you didn't provide the reduction potentials in the table below.  So, I looked them up and find them to be

Cu2+ +2e- ==> Cu(s)  Eº = +0.34 V

Zn2+ + 2e- ==> Zn(s)  Eº = -0.76 V

Net ionic equation:  Cu2+(aq) + Zn(s) ==> Cu(s) + Zn2+(aq)

b)  Eºcell = 0.34 V + 0.76 V = 1.10 V

c)  ∆Gº = -nFEº  where n = number of electrons transferred (2) and F = 96,485 C/mol e- and Eº = 1.1 V

d)  Again, there is no diagram

e)  same

f)  Use the Nernst equation  Ecell = Eºcell - 2.303RT/nF log Q  where R = 8.314; T = Kelvin; F = Faraday const. and Q = reaction quotient, i.e. products/reactants

g)  the cell voltage is an intensive property.  That should help you answer this part of the question

Explanation:

its not much but i hoped this helped

Answer:

[tex]NO_2[/tex] and [tex]La_2O_7[/tex]

Explanation:

Nitrogen:

[tex]\frac{42.05}{14}=3[/tex]

Oxygen:

[tex]\frac{95.95}{16}=6[/tex]

Ratio:

[tex]3:6=1:2[/tex]

So empirical formula becomes [tex]NO_2[/tex]

-----

Lanthanum:

[tex]\frac{7.33}{139}=0.0527[/tex]

Oxygen:

[tex]\frac{2.96}{16}=0.185[/tex]

Ratio:

[tex]0.0527:0.185=1:3.5=2:7[/tex]

So empirical formula becomes [tex]La_2O_7[/tex]

Answer:

Na

Explanation:

Sodium

Answer:

magnesium and oxygen

Explanation:

Answer:

The internal combustion engine in the car converts the potential chemical energy in gasoline and oxygen into thermal energy which is transformed into the mechanical energy that accelerates the vehicle (increasing its kinetic energy) by causing the pressure and performing the work on the pistons.

Explanation:

Answer:

What is the specific heat for the aluminum wire?

0.82

What is the specific heat for the steel wire?

0.47

What is the specific heat for the lead pellets?

0.25

Explanation:

Answer:

What is the specific heat for the aluminum wire?

0.82

What is the specific heat for the steel wire?

0.47

What is the specific heat for the lead pellets?

0.25

Explanation:

This is the person above me. All credits go to them.

Answer:

(+20) + (-18) = +2

Explanation:

Answer: amount of O2 is 3.8 moles

Explanation: reaction. 2 H2O2 -> 2 H2O + O2

Two moles H2O2. Produces one ole Oxygen

Answer:

The amount of HI is "64 grams".

Explanation:

The given values are:

Volume,

= 0.500 L

Molarity,

= 1.00 H

Molar mass of HI,

= 128

Now,

The moles of HI will be:

=  [tex]Molarity\times Volume[/tex]

On substituting the values, we get

=  [tex]1.00\times 0.500[/tex]

=  [tex]0.5 \ mol[/tex]

hence,

The amount of HI will be:

=  [tex]Moles\times Molar \ mass[/tex]

=  [tex]0.5\times 128[/tex]

=  [tex]64 \ grams[/tex]

Answer:

no ablo inglés porfavor amigos

Answer:

C.

Explanation:

Answer:

Molarity is the amount (in mole) of solute in a solvent. If the solute is very volatile, then it will evaporated from the solution as temperature rising. So the amount of solute is decreasing, causing the molarity decreasing. If the solvent itself volatile, then the molarity will increase.

(Looked up the answer for you)

The relationship between evaporation and molarity is; the rate of evaporation of will decrease as the molarity increases

Molarity (M) is defined as the amount of a substance in a certain volume of solution. Molarity can also be defined as the number of moles of a solute per liters of a solution.

Now, the rate of evaporation of will decrease as the solute concentration increases due to the fact that for the same surface area for evaporation, as the concentration of the solute increases, less water molecules will get exposed to escape from the water surface.

Read more about Evaporation and Molarity at; https://brainly.com/question/14718840

Answer:

temperature!!!

Explanation:

Reactant concentration, the physical state of the reactants, and surface area, temperature, and the presence of a catalyst are the four main factors that affect reaction rate.

Answer:

844.4cm³

Explanation:

Using Boyle's law equation;

P1V1 = P2V2

Where;

P1 = initial pressure (mmHg)

P2 = final pressure (mmHg)

V1 = initial volume (cm³)

V2 = final volume (cm³)

According to the information in this question,

V1 = 650cm³

P1 = 760mmHg

P2 = ?

V2 = 10% reduction of V1

10% of 650 = 10/100 × 650

65

V2 = 650 - 65 = 585cm³

Using P1V1 = P2V2

P2 = P1V1 ÷ V2

P2 = (760 × 650) ÷ 585

P2 = 494000 ÷ 585

P2 = 844.44

final pressure (P2) = 844.4cm³

Answer:

The initial volume in mL is 5959.2 mL

Explanation:

As the number of moles of a gas increases, the volume also increases.  Hence, number of moles and volumes are directly proportional i.e

n ∝ V

Where n is the number of moles and V is the volume

Then, n = cV

c is the proportionality constant

∴n/V = c

Hence n₁/V₁ = n₂/V₂

Where n₁ is the initial number of moles

V₁ is the initial volume

n₂ is the final number of moles

and V₂ is the final volume.

From the question,

n₁ = 0.693 moles

V₁ = ?

n₂ = 0.928 moles

V₂ = 7.98 L

Putting the values into the equation

n₁/V₁ = n₂/V₂

0.693 / V₁ = 0.928 / 7.98

Cross multiply

∴ 0.928V₁ = 0.693 × 7.98  

0.928V₁ = 5.53014

V₁ = 5.53014/0.928

V₁ = 5.9592 L

To convert to mL, multiply by 1000

∴ V₁ = 5.9592 × 1000 mL

V₁ = 5959.2 mL

Hence, the initial volume in mL is 5959.2 mL

Answer:no I don’t sorry

Explanation:

Answer: The sample absorbed 3061.565J

Explanation:

Given that  

Mass of water  = 335g

Initial temperature  = 24.5°C

Final temperature = 26.4°C

Heat  absorbed by the sample is given as  = mass x specific heat of water x  temperature change

Heat  absorbed,q=mCΔt

The specific heat of water,C  = 4.81J/g°C

Therefore,  Heat absorbed,q  = 335 x 4.81h x (26.4  - 24.5)  = 3061.565J

Answer:

2660.57 J

Explanation:

26.4 - 24.5 = 1.9

335 x 4.18 x 1.9 = 2660.57 J

That is the correct answer.

Answer:Number 2 might be the second one

Explanation:

Answer:

volume 2-     4.011 L

Answer:

evapouration is a type of vaporization that occur on the surface of liquid as it change into the gas phase.

hope it helps.

Evaporation happens when a liquid turns into a gas. It can be easily visualized when rain puddles “disappear” on a hot day or when wet clothes dry in the sun.

The Answer is LEAD ......................

Answer:

a. Disminuye.

b. Disminuye.

Explanation:

¡Hola!

En este caso, considerando que tenemos una reacción en la cual se podría asumir que tanto la concentración de monóxido de carbono y la de oxígeno contribuye a la velocidad de reacción, de acuerdo a la siguiente cinética elemental:

[tex]r=k[CO]^2[O_2][/tex]

Al aplicar los siguientes cambios, resultaría:

a. En este caso, bien sabemos que la velocidad de reacción es aumentada al adicionar un catalizador ya que la constante de velocidad aumenta al disminuir la energía de activación; no obstante, al retirar el catalizador, la energía de activación aumentaría y por consiguiente la velocidad de reacción disminuiría.

b. En este caso, dado que la relación entre el oxígeno y la rapidez de reacción es directamente proporcional, es possible para nosotros determinar que al eliminar parte del oxígeno, la concentración disminuye y por ende la velocidad de reacción también.

¡Saludos!

Answer:

I don't know

Explanation:

mixture of iron powder and sulphur heated it glows because sulphur and iron are more reactive metals that they shine and sulphur can react with water produce fire it's write

Answer:

false

Explanation:

it gets nourishment from the storage tissues in the seeds, when it develops into a young plant with roots, then it takes nutrients from the soil