which one is not allotropes of carbon? ​

[tex]\boxed{\sf °F=\dfrac{9}{5}°C+32}[/tex]

[tex]\\ \sf\longmapsto °F=\dfrac{9}{5}(197)+32[/tex]

[tex]\\ \sf\longmapsto °F=\dfrac{1773}{5}+32[/tex]

[tex]\\ \sf\longmapsto °F=354.6+32[/tex]

[tex]\\ \sf\longmapsto °F=386.6°F[/tex]

[tex]\rule{200pt}{5pt}[/tex]

[tex]\boxed{\sf K=°C+273}[/tex]

[tex]\\ \sf\longmapsto K=197+273[/tex]

[tex]\\ \sf\longmapsto K=470K[/tex]

Explanation:

Leopards have 32 teeth, 4 of which are long, pointed canine teeth. Canine teeth are used to kill prey. Other teeth are for cutting flesh and grinding bone

Glucose is a molecular substance therefore, there are no ionic species in glucose.

Ionic substances dissolve in water to yield ions. Molecular substances do not produce ions in solution. The conductivity of ionic solutions owes to the presence of ions in solutions. Molecular solutions do not conduct electricity due to the absence of ions.

Glucose is a molecular substance hence they are are no ions present hence glucose does not conduct electricity.

Learn more:  https://brainly.com/question/13440572?

Answer:

Add a volume of a solution of known concentration is added to a volume of another solution in order to determine its concentration. Solutions in which a few drops of phenolphthalein have been added turn from colorless to brilliant pink as the solution turns from acidic to basic.

If you want the method:

Method

1) Use a pipette and pipette filler to add 25 cm3 of alkali solution to a clean conical flask.

2) Add a few drops of a suitable indicator and put the conical flask on a white tile.

3) Fill the burette with dilute acid. Flush the tap through to remove any air bubbles. Ensure the burette is vertical.

4) Slowly add the acid from the burette to the conical flask, swirling to mix. (The mixture may at first change colour, and then back again when swirled.)

5) Stop adding the acid when the end-point is reached (when the colour first permanently changes). Note the final volume reading.

6) Repeat steps 1 to 5 until three results are repeatable (in close agreement). Ideally these should lie within 0.10 cm3 of each other.

I hope it helps.

Answer:

To conduct a titration experiment, first fill the burette with an acid or base solution of known concentration. After that, take a burette reading from the top of the miniscus down to the bottom. Then, underneath the burette, place a flask containing an unknown concentration of acid or base. After that, fill the flask halfway with the appropriate indicator and shake it up. Add your titrate to the flask one drop at a time while stirring constantly. Continue to add the titrate until the color change is noticeable. Finally, take one more look at the burette to make sure everything is correct.

Explanation:

Hope it helps:)

Answer:

B. C6H1206(s) + 602(9) → 6H20(l) + 6C02(9)

Explanation:

You can see that it's balanced;

C6H1206(s) + 602(g)           →            6H20(l) + 6C02(g)

 C  ⇒ 6                                                        C ⇒ 6

 H  ⇒ 12                                                       H ⇒ 6 x 2 = 12

 O  ⇒ 6 + (6 x 2) = 18                                  O ⇒ 6 + (6 x 2) = 18

Answer:

77%

Explanation:

The formula for finding percent change is change/original.

So, you have to do 0.3/0.39

You have to divide this to get 0.769 which can be rounded 0.77

0.77 as a percentage is 77%

So, the percentage mass increase of the carrot is 77%

Answer:

c>b=a

Explanation:

It is important to note that mass does not affect the average motion/energy per molecule, but temperature does. the higher the temperature the faster the particles are. A has the same temperature as B, so they have the same amount of motion. C is warmer than A and B, so the average motion of the particles in beaker C is the largest

A vessel that contains a mixture of nitrogen and butane has a pressure of 3.0 atm at 126.9 °C and a pressure of 1.0 atm at 0 °C. The mole fraction of nitrogen in the mixture is 0.33.

A vessel contains a gaseous mixture of nitrogen and butane. At 126.9 °C (400.1 K) the pressure is due to the mixture is 3.0 atm.

We can calculate the total number of moles using the ideal gas equation.

[tex]P \times V = n \times R \times T\\\\n = \frac{P \times V}{R \times T} = \frac{3.0 atm \times V}{0.082 atm.L/mol.K \times 400.1 K} = 0.091 mol/L \times V[/tex]

At 0 °C (273.15 K), the pressure due to the gaseous nitrogen is 1.0 atm.

We can calculate the moles of nitrogen using the ideal gas equation.

[tex]P \times V = n \times R \times T\\\\n = \frac{P \times V}{R \times T} = \frac{1.0 atm \times V}{0.082 atm.L/mol.K \times 400.1 K} = 0.030 mol/L \times V[/tex]

The mole fraction of nitrogen in the mixture is:

[tex]X(N_2) = \frac{0.030 mol/L \times V}{0.091 mol/L \times V} = 0.33[/tex]

A vessel that contains a mixture of nitrogen and butane has a pressure of 3.0 atm at 126.9 °C and a pressure of 1.0 atm at 0 °C. The mole fraction of nitrogen in the mixture is 0.33.

Learn more: https://brainly.com/question/2060778

The thermal energy of a material increases with temperature. Therefore, the radiator  has the higher thermal energy.

When the temperature rises, a type of energy called thermal energy is produced. The amount of thermal energy usually directly inversely proportional to the object's change in temperature. Thermal energy takes the form of heat.

The thermal energy of a material increases with temperature. The quicker motions of the substance's atoms and molecules are what cause thermal energy to grow as temperature rises.

In some cases, a substance's molecules will separate from one another and leave because the temperature is just so high. Unexpectedly, thermal energy also affects the states of matter. The radiator  has the higher thermal energy.

Therefore, the radiator has the higher thermal energy.

To learn more about thermal energy, here:

https://brainly.com/question/30288262

#SPJ6

Answer:

Ba 80.148%. H 1.77% O 18.657%

The volume of the gas is 27 ml

The calculation can be done as follows

The first step is to convert the pressure to atm

convert 2280 tors to atm

760 tors= 1 atm

= 2280/780

= 3 atm

The formula is

PV= nRT

The next step is to write out the parameters

Pressure= 3 atm

Temperature= 21 °C

no of moles= 32.1 mole

volume= ?

(r)constant= 8.314

3 × v= 32.1×8.314×21

3v= 81.080

V= 81.080/3

V= 27 ml

Hence the volume of the gas is 27 ml

Please see the link below for more information

https://brainly.com/question/15568262?referrer=searchResults

Answer:

3

Explanation:

The volume of titrant required for the titration would be 27.44 mL

From the illustration, the initial titrant volume was 2.51 mL. This figure represents the initial reading on the burette.

In the same vein, the final volume of the titrant was 29.95 mL. This figure represents the final reading on the burette.

In order to get the volume of titrant used:

Volume of titrant used = final volume - initial volume

                             = 29.95 - 2.51

                                = 27.44 mL

More on the volume of titrant used in titrations can be found here: https://brainly.com/question/4250180

Answer:

Collision theory states that molecules must collide to react. For most reactions, however, only a small fraction of collisions produce a reaction.

The molecules of the two gases will have the same kinetic energy at room temperature.

The average kinetic energy of gaseous molecules can be calculated using the formula:

Kinetic Energy = 3/2RT, where R = constant and T = temperature in Kelvin

This means that the kinetic energy of a gaseous molecule is dependent on the temperature of the molecule only.

In other words, the molecular mass of molecules of gases has no bearing on the kinetic energy of each molecule.

More on kinetic energy of gases can be found here: https://brainly.com/question/999862

Answer:

21.86 grams

Explanation:

It is important to note that for every mol of Na3PO4 there is, 3 mols of Na ions are produced.

Na+=1m(0.4l), so mols of Na3PO4= 0.4/3= 0.13333... mols

the molar mass of Na3PO4 is 163.94 grams/mol. 0.1333*163.94=21.86 grams of Na3PO4.

Answer -ˋˏ ༻༺ ˎˊ-

A common use for gravity filtration is for separating anhydrous magnesium sulfate (MgSO4) from an organic solution that it has dried (Figure 1.68b). Anhydrous magnesium sulfate is powdery, and with swirling in an organic solvent creates a fine dispersal of particles like a snow globe.

Answer:

At temperatures > 400 °C, CCl4 reacts with H2O over a MgO catalyst to yield HCl and CO2.

Answer:

3O2→ 2O3

Explanation:

by multiplying 2 by 3 we get 6 on both sides

Answer:

D, two of the above, oxygen and hydrogen.

Explanation:

To solve this problem we can either use orbital stuff or common knowledge. Oxygen and hydrogen are known to form O2 and H2, while sodium forms metallic bonds between the atoms.

Answer:

C4H9

Explanation:

If H = 15.88%

Then C = 100.00 – 15.88 = 84.12

Divide each % value by respective atomic mass

H = 15.88/1 = 15.88

C = 84.12/12 = 7.01

Divide through by smaller value

H = 15.88/7.01 = 2.26

C = 7.01/7.01 = 1

Remove fraction , multiply by 4

H = 9

C = 4

Empirical formula = C4H9

The hydrocarbon could be ( C4H9)2 = C8H18 = octane.

Answer:

1 would be the answer

protons = atomic # I think

Answer:

hydrogen

Explanation:

hydrogen has the atomic number of 1 which means that hydrogen has one proton and is neutral so it has one electron as well.

cosh(-cosh(-CH

Simplify the expression using the symmetry of hyperbolic functions

cosh(cosh(CH))

Simplify the expression using the symmetry of hyperbolic functions

the answer is cosh(cosh(CH))

Answer:

the correct answer is A. please mark me brainlist

Explanation:

Answer:

geon, Andreas Vesalius. Vesalius describes what he observes during the public dissection of human corpses. By dissecting human bodies, preparing muscles, tendons, and nerves down to the smallest detail, Vesalius is able to prove more than 200 errors in Galen’s anatomical works.

Explanation:

With his comprehensive scientific studies of human bodies, the young professor of medicine not only revolutionizes anatomy, but consequently, the whole science of medicine.

I know I never completely answered your question, I just wanted to explain it was E. None of the above.

Answer:

law of conservation of energy

Before

P1 : 748 mmHg

V1 : 22.5 L

After

P2 : 725 mmHg

V2 : ?

748 mmHg / 22.5 L = 725 mmHg / V2

Cross Multiply...

748 mmHgV2 = 16312.5 mmHgL

748 mmHgV2 / 748 mmHg = 16312.5 mmHgL / 748 mmHg

V2 = 21.808155 L

V2 = 21.8 L (sig figs)

Answer:

you see le bear

you brain sends signals

your heart and lungs receive said signals

spring to action

Answer:

12

Explanation:

There are 4 sulfur atoms in SO4

4×3=12

This means that it turns into 3×(SO4)

=3SO4