Can someone help me out?

Answer:

a

Explanation:

i just took the quiz

Answer:

C₃H₈O₃

Explanation:

Let's assume we have 100 g of said compound. Then we would have:

Now we convert those masses into moles, using their respective atomic weights:

Then we divide those moles by the smallest number among them:

Finally we multiply those numbers by 3, so as to convert the 2.68 of H into an integer:

Thus the empirical formula is C₃H₈O₃

Answer:

i think its 10 miles per hour

Answer:

B. -5.58°C.

Explanation:

Hello!

In this case, since the freezing point depression is computed as follows:

[tex]\Delta T_f=-i*m*Kf[/tex]

Whereas i=1 as the van't Hoff's factor of sugar (nonionizing solute), m=3mol/1kg=3mol/kg as the molality and Kf=1.86 °C/(mol/kg) as the freezing point depression constant for water. In such a way, we plug in to obtain:

[tex]\Delta T_f=-1*3\frac{mol}{kg} *1.86\frac{\°C}{mol/kg} \\\\\Delta T_f=-5.58\°C[/tex]

Now, since the freezing point of pure water is 0°C, we infer that freezing point of such solution is:

B. -5.58°C.

Best regards!

Answer:

because iron is magnetic and sand is not

Explanation:

Answer:

group 15 ( the nitogen group)

Explanation:

Answer:

0.670 mol

Explanation:

Step 1: Write the balanced reaction for the decomposition of alumina

2 Al₂O₃ ⇒ 4 Al + 3 O₂

Step 2: Calculate the moles corresponding to 34.2 g of Al₂O₃

The molar mass of Al₂O₃ is 101.96 g/mol.

34.2 g × 1 mol/101.96 g = 0.335 mol

Step 3: Calculate the moles of Al produced from 0.335 moles of Al₂O₃

The molar ratio of Al₂O₃ to Al is 2:4.

0.335 mol Al₂O₃ × (4 mol Al/2 mol Al₂O₃) = 0.670 mol Al

Answer:

Titanium(IV) Sulfide

Explanation:

Answer:

- Because it has or not the same number of atoms at each side.

- Because the mass of reactants and product is or not the same after the reaction.

Explanation:

Hello!

In this case, since the law of conservation of mass states that matter cannot be created nor destroyed; when we see a chemical reaction, we need to make sure that the amount of atoms is the same at both reactants and products; for instance the formation of water requires four hydrogen atoms and two oxygen atoms at both reactants and products sides as shown below:

[tex]2H_2+O_2\rightarrow 2H_2O[/tex]

Another way is by proving that the total mass of products equals the total mass of reactants once the reaction has gone to completion.

Best regards!

Answer:

529g/L

Explanation:

The concentration in chemistry is defined as the amount of solute in a determined amount of solution. The concentration in g/L means the amount of grams of solute (In this case, barium acetate), per liter of solution.

To solve this problem we need to find grams of solute (52.9g, already given) and the volume in liters (Converting 100mL to liters):

Volume:

100mL * (1L / 1000mL) = 0.100L

And concentration in g/L is:

52.9g / 0.100L =

Answer:

B

Explanation:

The Niels Bohr's atomic model superior to all the earlier models is because it showed how the electron could orbit the nucleus without falling into it

Answer:

A precipitation is answer

Answer:

None have backbones

No cell walls

Multicellular

Includes radial or bilateral body symmetry.

Explanation:

Why can gases and liquids be paired but not solids?

The atoms and molecules in gases are much more spread out than in solids or liquids. They vibrate and move freely at high speeds. A gas will fill any container, but if the container is not sealed, the gas will escape. Gas can be compressed much more easily than a liquid or solid.

Answer:

its 2

Explanation:

Answer:

Phosphoric acid

Explanation:

Answer:

Phosphoric acid

Explanation:

Phosphoric acid is an oxyacid, which is formed when hydrogen combines with the polyatomic ion phosphate. The polyatomic ion for phosphate is [tex]PO_4^-3[/tex]. To combine this with hydrogen, we "criss-cross" the charges of phosphate (which has a charge of -3) and hydrogen (which has a charge of +1) to get [tex]H_3(PO_4)_1[/tex], the same as [tex]H_3PO_4[/tex].

To answer this question, we essentially reverse these steps. First, we would recognize that this is a hydrogen atom bonded with phosphate. Because phosphate is a polyatomic ion, we know that this is an oxyacid. Because it involves phosphate, we call it phosphoric acid.

I hope this helps!

Answer:

One of the major effects of heat transfer is temperature change: heating increases the temperature while cooling decreases it. We assume that there is no phase change and that no work is done on or by the system. Experiments show that the transferred heat depends on three factors—the change in temperature, the mass of the system, and the substance and phase of the substance.

Answer:

100

Explanation:

Answer:

c

Explanation:

The ocean water transfers thermal energy to the area, warming the equatorial waters. Therefore, the correct option is option C.

In physics and engineering, the phrase "thermal energy" is thrown around in a lot of different situations. It can relate to a variety of distinct physical notions. They include radiation and a body of matter's inherent energy, also known as enthalpy.

Through means besides just thermodynamic work or the movement of matter, including such conduction, radiation, or friction, heat is energy that is moved into or out of a thermodynamic system. Heat is not a property of any single system or something that is "contained" within it; rather, it is a quantity that is transmitted across systems. Internal energy and enthalpy, on the other hand, are characteristics of a single system. The ocean water  transfers thermal energy to the area, warming the equatorial waters.

Therefore, the correct option is option C.

To know more about thermal energy, here:

https://brainly.com/question/30819997

#SPJ7

Answer:

Structurally, plant and animal cells are very similar because they are both eukaryotic cells. They both contain membrane-bound organelles such as the nucleus, mitochondria, endoplasmic reticulum, golgi apparatus, lysosomes, and peroxisomes. Both also contain similar membranes, cytosol, and cytoskeletal elements.

Explanation:

I hope it's help

Answer:

C Group 11

Explanation:

Group 11, by modern IUPAC numbering, is a group of chemical elements in the periodic table, consisting of copper (Cu), silver (Ag), and gold (Au).

These elements show highest electrical conductivity.

Answer:

C Group 11

Explanation:

Group 11, by modern IUPAC numbering, is a group of chemical elements in the periodic table, consisting of copper (Cu), silver (Ag), and gold (Au).

These elements show highest electrical conductivity.

Explanation:

Answer:

hope it helps you

Explanation:

i think is d

Answer:

In graph theory, a component of an undirected graph is an induced subgraph in which any two vertices are connected to each other by paths, and which is connected to no additional vertices in the rest of the graph.

Answer:

Explanation:

p-diaminobenzene is popularly known as p-phenylenediamine. It undergoes a condensation reaction with metal halides. As a white solid (p-diaminobenzene), it can be darkened by air oxidation. The reaction showing the condensation of p-phenylenediamine with (CoCl)₂ can be seen in the image attached below.

Answer:

create a plan

the ways of of a student to set a goal

1. Write clear and measurable goals

2.Create a specific plan for each goal

3.Read your goals daily and visualize yourself accomplishing them

4. Reflect yourself to see if you are on target

5. Revise your action plans if needed.

1.)make a plan

2.)make a schedule

5.)pace him or herself

Answer:

Pathway

Explanation:

Pathways and Circuits are different things, so it can't be part of it.